Nothing in cart
Great outside light cover and switch.
Estimated dispatch: Fri 20 Nov
Postage Australia Wide
Enter your postcode for a delivery estimate.
Check arrival using your postcode.
Show us a photo or model number. We’ll help you check before you buy.
Buy the part we recommend for your setup. If we get it wrong, we’ll cover return postage and delivery of the correct replacement.
Winegard FreeVision HV Retrofit Kit replaces the antenna head and elevating arm assembly on an existing Winegard Sensar installation. It retains your roof-mounted base, internal winding and rotation controls, and wall-plate power supply, rather than replacing the complete antenna system. The Winegard plastic elevating gear is included.
The optional Wingman is NOT required for this model, as the technology is built in as standard.
For an Antennatek conversion, the supplied retrofit guide specifies reusing the original Antennatek elevating gear, pin and clips, not the supplied Winegard gear. The Antennatek gear needs packing securely onto the larger Winegard mast tube with the glue/epoxy or tape/plastic shims described in the guide; this is not a straight gear swap.
When replacing an original Sensar, the installation procedure requires cutting off and refitting the antenna-end coax connector. A replacement connector is not supplied and must suit your existing cable.
Raise the antenna fully before rotating it towards the transmitter, switch the wall-plate power supply on and run a digital channel scan. Align the handle and ceiling-plate pointers before lowering. Stow the antenna before travelling and when wind speeds reach 113 km/h; do not leave it partly raised.
Great outside light cover and switch.
Reliable company to deal with.Great communication.Item arrived on time in good condition.
Great products and very good service.