Nothing in cart
Seal Service Kit was dispatched immediately and arrived quickly allowing me to service my Trail-a-Mate ready for a weekend away caravanning.
9th order by Graham from NSW
CMS J-Series Interconnecting Cable - 500mm
$26.95
Estimated dispatch: Tue 10 Nov
Postage Australia Wide
Enter your postcode for a delivery estimate.
Check arrival using your postcode.
Show us a photo or model number. We’ll help you check before you buy.
Buy the part we recommend for your setup. If we get it wrong, we’ll cover return postage and delivery of the correct replacement.
DIY 240V, 10A power outlet with auto switch, CMS.
CMS products provide a DIY 240V wiring solution for your RV. The 10A power outlet fits the DIY 240V CMS cables.
This would typically be the last outlet in a circuit as it does not provide a second connection at the rear. It incorporates an automatic switch that will cut off current (double-pole) when an appliance is removed from the socket.
The screw holes are 65mm apart horizontally and 81mm apart vertically. You require 60mm from the outside mounting face to the rear of the inlet to accommodate it fully within a wall. For thinner walls it will extend into the cabin, or needs a homemade backing plate added to the outside. Backing plates are not available for this item.
Use only when fitted to a caravan wall. Use the gasket to mark the wall cut-out, pass the cable through the gasket and connect it to the rear of the outlet, then secure the gasket and outlet over the cut-out with the fixing screws fully tightened. The rear installation coupler must be positioned away from readily accessible areas and connected or disconnected only without load.
Seal Service Kit was dispatched immediately and arrived quickly allowing me to service my Trail-a-Mate ready for a weekend away caravanning.
the part was on back order so caravans plus constantly kept me updated on progress.
Great service and highly recommend using caravan plus will be ordering in the future