Thermistor Cable Suits myCOOLMAN CCP / CCPR / MCMR / CEP Fridges

Description

Genuine replacement thermistor and cable for myCOOLMAN CCP, CCPR, MCMR and CEP compressor fridges. The thermistor senses the cabinet temperature for the fridge controller.

For a dual-zone fridge, myCOOLMAN recommends replacing both thermistors at the same time for correct and consistent operation. This listing supplies one thermistor cable; order two to replace both.

Features

• 1 year warranty.

Specifications

• Manufacturer Part Number: MCM313-30105
• Brand: myCOOLMAN
• Compatibility: myCOOLMAN CCP, CCPR, MCMR and CEP compressor fridges
• Quantity: 1 thermistor and cable
• Shipping Weight: 100 grams.
• Shipping Dimensions: 1 cm x 5 cm x 5 cm.

Our Comments

Instructions from Customer:

1. Flip the fridge upside down, take all the screws holding the control panel cover, and fold the control panel cover out without disconnecting any of the wiring
2. Locate the thermistor plug and disconnect. Mine had some glue all over it I had to pull off first - I assume to make sure the plug never shakes loose
3. Follow the old thermistor cable around till you find where it goes into a tube in the side of the fridge. There is a big blob of black silicon stuff sealing the cable to the back of the fridge that you'll need to pull off (but keep this). And you need to unscrew the little plastic harness.
4. Remove the old thermistor
5. Insert the new thermistor into the tube in the side of the fridge and seal it off with the blob of black silicon looking stuff. Replace the little plastic wiring harness just below.
6. Feed the new thermistor wire through to the back of the control board along a similar route to the old one, and plug into its slot.
7. Replace the control panel cover. Be careful not to overtighten the screws as a lot of them only screw into the plastic housing.
8. Plug the fridge back in to power and check its operation

Community Photos