PDF Product Manual (1.7mb)
Below is a summary of the contents of this PDF. You can also view or save the original full PDF. The products that this PDF relate to are listed at the bottom.
Sirocco II Fan Customer Service and Technical Support Document
Operating Instructions
Installation
- Pre-Installation Testing: Before installing, test the fan's positioning. Insert 2 nuts into the hex holes on the back of the backing plate. Use the double-sided tape to temporarily attach the backing plate to the desired surface. Note: The adhesive is semi-permanent.
- Securing the Backing Plate: Use six #6 fasteners to securely attach the backing plate to the wall.
- Wiring:
- Positive and Negative Wires: Attach the wire marked positive to the positive base screw and the negative wire to the negative base screw.
- Securing Wires: Follow the illustrated order to secure wires. Place the ferrite beside the base screw, followed by the lock washer and wire to the base screw.
- Wire Routing: Depending on the installation, feed the wire through the notch on either end of the base or through the corresponding holes on the backing plate.
- Attaching the Fan: Slide the fan base onto the firmly secured backing plate and secure the fan to the backing plate with the two provided screws.
Operation
- Fan Blade Clearance: Ensure the fan blade is clear of obstructions. Lock the fan arm in position before turning on.
- Lock Latch: Flip the lock latch upwards to unlock the fan arm, adjust the direction, and push the latch back down to lock.
- Speed Settings: Press the Power/Speed button to adjust fan speed:
- Once for low speed
- Twice for medium speed
- Three times for high speed
- Four times to turn the fan off
- Timer Feature: The fan has a timer for 3, 6, 9, or 12 hours.
- To set, press the Timer Button 1-4 times corresponding to the desired time. The LED bar will indicate the selected time. To cancel, press the Timer Button until the LED bars disappear, then press the Power/Speed button to turn off.
Specifications
- Fan Speed and Current Draw:
- Low: 0.12A (12V) / 0.06A (24V) | 1200±100 RPM
- Medium: 0.22A (12V) / 0.11A (24V) | 1500±100 RPM
- High: 0.35A (12V) / 0.21A (24V) | 1800±100 RPM
- Maximum Airflow: 140 CFM (Cubic Feet Per Minute) or 238 m³/h (Cubic Meters per Hour)
Care and Maintenance
Minimal maintenance required. Turn off power before cleaning.
Use a vacuum for dust and a dry cloth for surface cleaning. Avoid gasoline, thinner, or harsh chemicals.
Replacement Kit
The motor is designed for extensive operation. If the fan spins slower over time, consider a motor replacement.
Safety
Features reverse polarity and overcurrent protection.
Avoid positioning close to objects that may obstruct airflow.
Not for outdoor use, wet surfaces, or immersion in water.
Ensure the power supply cord is intact. Do not use near high-temperature sources.
Warranty
The product has a 1-year limited warranty from the date of purchase, covering defects in workmanship and/or materials. Damage from improper handling, accidents, or unauthorized repairs are not covered.
For warranty claims, contact customer service without including specific contact details.
Product Registration
Encourages product registration for support and warranty purposes. Specific details for registration are not included.
This document serves as a comprehensive guide for customer service and technical support staff, providing detailed instructions, specifications, and safety information for the Sirocco II fan.