3 November: Over 90% of orders sent within 2 business hours. Posting Australia wide.
CaravansPlus Accessories Shop
Cart
CaravansPlus.com.au

PDF Product Manual (1,705Kb)

Below is a summary of the contents of this PDF. You can also view or save the original full PDF. The products that this PDF relate to are listed at the bottom.

SHURFlo Pentair Water CITY/DOCKSIDE POTABLE WATER ENTRY - Technical and Customer Service Guide

Installation Instructions Overview

The SHURflo Water Entry is designed to regulate pressure, ensuring a nominal pressure level while preventing high-pressure surges that could damage the plumbing system. It features an internal backflow preventer to stop reverse flow when the potable water pump is in use.

Caution: The maximum inlet pressure should not exceed 125 psi (8.6 bar).

Wall/Bulkhead Mounting Instructions

  1. Location:

    Choose a location that allows easy access to the outlet plumbing. It is recommended to tee into the cold water line after the pump but before the water heater or fixtures.

  2. Opening:

    Cut a 3 inches dia. (8.75 cm) opening.

  3. Mounting:

    Insert the unit into the opening, align, and mark the four mounting holes. Use #8 screws/hardware suitable for the wall construction and environment (not included).

  4. Drilling:

    Drill the four marked holes for the fasteners. Consider making plumbing connections before fully mounting the unit if easier.

  5. Tubing:

    If connecting to rigid plumbing, use at least 1 ft. (30 cm) of 1/2 inch I.D. (13mm) flexible high-pressure tubing.

    Caution: Direct connection to plastic or rigid pipe is not advised due to potential noise and damage from vibration or stress.

  6. Swivel-Barb Fitting:

    The included fitting has a "taper seal" for a watertight connection when hand-tightened (Max. torque 8-10 ft/lb. or 10-13 Nm). Secure tubing with stainless steel clamps of the correct size.

  7. Sealing:

    Use suitable caulking to seal the flange and prevent exterior water damage.

In-Line Water Entry Instructions

  1. Garden Hose Adapter:

    Install the included plastic garden hose adapter to the 2-14 thread of the Water Entry. Use thread sealers sparingly to avoid over-torquing (Hand-Tighten Only! Max. torque 8-10 ft/lb. or 10-13 Nm).

    Caution: Over-torquing or bottoming threads may damage the unit, which is not covered under warranty. The Water Entry can be capped and left attached to the potable water hose during storage.

Performance Specifications

Limited Warranty

Troubleshooting and Maintenance

This guide is intended to provide comprehensive technical and operational information for customer service and technical staff handling SHURflo City/Dockside Potable Water Entry units. Always follow safety guidelines and local regulations during installation and maintenance.

Products Related to this PDF

SHURflo Mains Water Pressure Limiting Valve 50psi

SHURflo Mains Water Pressure Limiting Valve 50psi

3 In Stock Now.
$89.00
$76.95
View
Home