Stock Update - 27th July 2021Sorry, this item is not in our warehouse. We usually have at least 3 of these on our shelves but they have just been sold.
We already have another 19 on order with our supplier. 2 of the new ones are already allocated to other people who have placed orders with us.
We should have these again before any other shops, so if you find this product elsewhere we recommend you confirm they physically have it.
The supplier has told us to expect arrival around 30th of December.
Please place an order to reserve the next arrivals.
MaxxAir Vent Cover, 400mm x 400mm, All Weather Vent Cover,
This very popular Vent cover eliminates smoke, odours, heat build-up, mildew and mustiness. Lets in fresh air, but not rain.
- Fits most standard roof vent openings 355-400mm. Installs in about 10 minutes.
High impact plastic with UV inhibitors lets light into
the interior of the Campervan or Motorhome. Zero leak mounting system eliminates the need for drilling any holes in your RV roof.
Includes mounting hardware.
All hardware provided with Zero-Leak Mounting System is made of stainless
steel or aluminium for durability and long life.
Place the Vent Cover over the roof vent with the louvre area facing the rear of the vehicle. After verifying that the Vent Cover is
centred over the roof vent, trace on your roof (with a pencil) the location of the slots in the Vent Cover's mounting flange.
Position a mounting bracket on your roof so that the slot in the bracket intersects one of the slot locations traced on the roof. For
maximum strength place the mounting brackets as close as possible to the outside corner of your existing roof vent frame.
Mark the location of the screw hole in the bracket onto your roof vent frame. Drill through the roof vent frame using a 3/16 Inch dia.
drill bit. Place one of the carriage bolts upward through the slot in the bracket and fasten the bracket to the roof vent wall using the
small bolt provided. The small washer, lock washer, and hex nut should be placed on the inside of the roof vent frame wall. Install two
brackets on each side of your roof vent as shown in the drawing.
Place the Vent Cover on the four upward pointing carriage bolts and fasten using the large washers and hex nuts provided. You may
have to push the head of the carriage bolt up into the bracket slot to prevent the carriage bolt from turning during tightening of the hex
A slight air gap between the base of the Vent Cover and the RV roof after
installation is normal and permits condensation to escape.
- 1 year warranty.
- Model: 650-04020, 008639, 50401150, 008639
- Brand: Maxxair
- Barcode: 00-933066
- Total base coverage 470mm x 470mm
- Approx height 300mm
- Not suitable for high powered fans.
- Shipping Weight: 1.71 Kgs.
- Shipping Dimensions: 24 cm x 49 cm x 48 cm.