Furrion Vision S Monitor Installation and Operation Guide

Package Contents Verification

Before beginning the installation, verify all items in the package against the 'What's in the box' section on the packaging box.

Pre-Installation Instructions

• Read and understand all safety-related instructions from the online user manual available at https://furrion.com/pages/download-navigation.
• Gather necessary tools: #2 Phillips head screwdriver, insulation tape, pencil, and a 5/8” hole saw (if drilling a new hole is required).

Installation

Mounting in Cab for Observation

1. Power Connection: Connect the cigarette lighter connector of the monitor power cable to a cigarette lighter socket in the vehicle.

2. Monitor Location: Choose a location that does not obstruct the driver's view and complies with local driving laws.

3. Mounting Method:

   • Windshield Stand: Clean the mounting area, remove the protective film from the suction cup, place it on the desired location, and push the locking arm downwards to secure.
   • Table Stand: Place the stand with non-slip pads on a stable surface and route the monitor power cable accordingly.

4. DC Connection: Connect the DC connector to the power socket on the monitor.

5. Adjustment: Rotate the monitor to adjust the visual angle as needed.

Mounting onto Vehicle Wall for Security

1. Preparation: Isolate the 12V / 24V power source by removing the key from the ignition.

2. Outline and Drill: Mark the outline of the mounting bracket on the vehicle wall, drill a 5/8” wiring hole for the power cable.

3. Cable Routing: Route the bare ends of the power cable through the wiring hole and connect them to the nearest 12V/24V power supply. Ensure proper isolation of all bare ends with insulation tape.

4. Bracket Installation: Fix the mounting bracket onto the marked location using two flat self-tapping screws provided.

5. Monitor Attachment: Align the ball on the bracket with the opening on the back of the monitor and push firmly to lock into place, ensuring good contact between the metal pins on the bracket and those on the monitor.

Pairing with Cameras

1. Initial Setup: Ensure the monitor and camera(s) are powered on.

2. Menu Navigation: Press the MENU button on the right of the monitor to enter the setup menu.

3. Pairing Selection: Tap PAIRING and select the camera to be paired with the monitor.

4. Camera Pairing: Press the MONITOR PAIRING button on the camera to initiate pairing.

5. Repeat Pairing: Follow the same steps to pair other available cameras. Erect antennas on the cameras and check signal strength.

Troubleshooting

If video from the camera does not appear on the monitor, ensure both devices are powered on and properly paired following the above steps.

For further support, refer to the complete user manual available at the provided Furrion website link. This guide serves as a comprehensive reference for customer service and technical staff in assisting users with the Furrion Vision S monitors.