PDF Product Manual (434kb)
Below is a summary of the contents of this PDF. You can also view or save the original full PDF. The products that this PDF relate to are listed at the bottom.
GL-TX-003-01 Wireless Remote Control Instruction Manual for Customer Service and Technical Staff
Introduction
The GL-TX-003-01 is a 6-button Multi-Function Remote designed to offer flexibility by allowing programming to single or multiple channels, tailored to individual user requirements.
Programming Instructions
Initial Setup
- Ensure the receiver module is powered and all channels are connected as per the installation instructions.
Programming Steps
Enter Learning Mode:
- Press and hold the programming button on the receiver module corresponding to the channel you wish to program.
- Hold for 5 seconds until the LED on the corresponding channel flashes green, then release the button.
- The channel is now in learning mode.
Programming the Remote:
- Press the button on the wireless remote control that you wish to program to the receiver.
- The receiver module will acknowledge the signal, and the LED will flash orange indicating that the remote control is now programmed to that channel.
Repeat or Exit:
- To program additional remote control channels, repeat the above steps for each channel.
- To exit programming mode, press the programming button again on the receiver module for the channel being programmed.
- If no button on the remote is pressed within 15 seconds, the system will automatically exit programming mode.
Memory Capacity
- Each channel can accept up to 20 codes. If the LED flashes red, the memory is full.
Deleting Memory
Enter Delete Mode:
- Press and hold the remote control button on the receiver for the channel from which you want to delete a memory.
- Hold for 5 seconds until the LED flashes green, then release the button.
- The channel is now in programming/single memory delete mode.
Deleting the Remote:
- Press the remote button you wish to delete from the receiver.
- The LED on the receiver corresponding to the channel will flash red, indicating the remote button is deleted.
Repeat as Necessary:
- If more than one button needs to be deleted from the receiver, repeat the above steps for each button.
Specifications
- Working Voltage: 3V
- Battery Type: CR2032 Lithium Battery
- Battery Life: Approximately 3 years under normal operation
- Working Frequency: 433.92 MHz
- Transmission Range: Up to 50 meters, depending on atmospheric conditions
- Coding Method: ASK
- Operating Temperature Range: -20 degrees C to +60 degrees C
Battery Connection & Replacement
- If the LED on the remote flashes quickly when a button is pressed, replace the batteries.
- To replace:
- Open the top cover of the remote.
- Insert new CR2032 batteries ensuring correct polarity.
- Close the housing.
- Test functionality by pressing any button. If the LED turns ON, the batteries are correctly installed.
Troubleshooting
- LED Flashing Red on Receiver: Memory full. Consider deleting unused codes.
- Remote Not Responding: Ensure batteries are installed correctly and are not depleted.
- Intermittent Operation: Check for interference or increase proximity to the receiver.
This manual serves as a comprehensive guide for customer service and technical staff to assist with programming, troubleshooting, and general inquiries regarding the GL-TX-003-01 Wireless Remote Control.