PDF Product Manual (958kb)
Below is a summary of the contents of this PDF. You can also view or save the original full PDF. The products that this PDF relate to are listed at the bottom.
Folding Picnic Table with LED - Installation and Troubleshooting Guide
For Customer Service and Technical Staff
This guide provides comprehensive instructions and technical information for the installation, operation, and troubleshooting of the Folding Picnic Table with LED. This document is intended to assist customer service and technical staff in addressing customer inquiries and providing support.
Product Overview
- Maximum Load: The table can evenly support up to 20kg when in the open position.
- Contents: The kit includes a picnic table and backing plate, screws, and keys.
Installation Guide
Pre-Installation Checks
- Safety Precautions: Disconnect 240V and 12V power supplies as well as LP Gas and other fuel sources to the RV.
- Wall Suitability: Ensure the RV wall is thick enough for the screws and can support the table's weight plus items placed on it. Additional bracing may be required.
Required Tools
- Drill and drill bit
- Pencil and measuring tape
- Screwdriver
- Masking tape
- Suitable silicone/sealant
- Cleaning cloth
Installation Steps
- Prepare the Area: Apply masking tape behind the table frame to protect the RV's paintwork.
- Positioning: Choose the installation spot carefully, avoiding electrical wires, plumbing, and gas lines. Use the wheel spat for alignment and mark the desired height with pencil lines.
- Drilling Pilot Holes: Mark the hole positions, including one for the LED power loom. Drill pilot holes appropriate for your RV's wall material. Note: Rivets may be required for some materials (not included).
- Sealing: Apply silicone/sealant around the frame's back and into the pilot holes for waterproofing and added strength.
- Securing the Table: Align the table with the pilot holes and insert screws. Ensure the LED power loom is fed through its designated hole.
- Back Plate Installation: Apply silicone/sealant in strategic locations on the back plate for additional strength. Align and press into place.
- Finishing Touches: Clean any excess silicone/sealant and apply a bead around the table edge for a neat finish.
- Curing Time: Allow the silicone/sealant to cure fully before driving or towing the RV.
- Electrical Connection: Connect the LED to a 12V FUSED power circuit. Red cable to positive, black to earth.
Operation Instructions
- Ensure the table is securely locked in the closed position when the RV is in motion.
- Use the provided keys to lock/unlock the table.
Troubleshooting and Warranty Claims
- Before Installation: Inspect the product for marks, scratches, or damage. Warranty claims for such issues will not be accepted once the product is installed.
- Warranty Duration: 12 months from the date of purchase or delivery if installed in or as a component of a vehicle or RV.
- Warranty Coverage: Includes defects in materials and workmanship under normal use. The supplier will repair or replace defective parts free of charge.
- Claim Process: Contact the supplier with proof of purchase, description of the defect, and compliance with maintenance schedules.
- Exclusions: The warranty does not cover improper installation, misuse, neglect, or use of non-genuine parts. Installation issues should be referred to the installer.
Note for Customer Service and Technical Staff
Always verify the installation site and conditions before proceeding with the installation.
For warranty claims, ensure the customer has complied with all installation and maintenance guidelines.
Advise customers to allow sufficient curing time for silicone/sealant to prevent issues with adhesion strength.
This guide is intended to provide all necessary information for the successful installation, operation, and troubleshooting of the Folding Picnic Table with LED. For further assistance, refer to the manufacturer's instructions and maintenance schedules.