Aircommand™ Heron 2.2 Split System Air Conditioner - 2.4kW Cool / 1.5kW Heat, White
The smallest split system unit available, generally suitable for pop tops up to 16ft with 2.4kWs of cooling and 1.5kw of heating.
The air handler (evaporator) has manual controls and is installed in the overhead cupboard, the compact condenser unit will fit under a dinette/seat or bottom of cupboard providing fitting flexibility.
FeaturesNormally suitable for caravans, motor homes and pop tops up to 5.2m (external dimension)
Supplied with a low profile condenser that can normally be fitted under beds and seats without increasing height
Able to give year round comfort with its ventilating, cooling and heating modes
Provides a heater element style warmth. This means quieter running noise and the ability to run in freezing ambient temperatures without any need to de-ice frozen coils
Fitted with easy to use controls. 1 year warranty.
SpecificationsModel: 100-00210 Coast to Coast, 002457 Camec, 4270001 DometicElectrical rating: 240V
Best for vehicle length: up to 5m (16ft)
Nominal Compressor Capacity: 2.6kW
Cooling Capacity: 2.4kW
Heating Capacity: 1.5kW
Maximum rated current, cooling: 5.0A
Maximum rated current, heating: 6.5A
Locked rotor current: 18A
Max Airflow: 297m3/h (82L/s)
Blower Speeds: 3 cooling, 1 heating
Installed Weight: 36kg
Condenser Height: 245mm
Condenser Width: 642mm
Condenser Depth: 450mm
Air Handler Height: 240mm
Air Handler Width: 380mm
Air Handler Depth: 250mm
Minimum cupboard dimensions required 490mm Wide x 290mm High x 310mm DeepShipping Weight: 42.00 Kgs.Shipping Dimensions: 60 cm x 60 cm x 55 cm.
The Heron are NOT suitable for installation by the DIY installer due to the requirement of making refrigerant lines.
In most states of Australia it is a requirement by law that connection of refrigerant lines be carried out by a licensed tradesperson.
The installer will place the Condenser unit usually on the offside of the RV resting on the floor or above a strengthened wheel arch.
The Air handler is placed in an upper cupboard up to 5metres away from the Condenser.
All wiring is included.
The installer must then make 2 copper pipe refrigerant lines with flared ends (flaring instructions are included BUT pipes are NOT included) one being 1/4" and one being 3/8" dia copper pipe (the 3/8" pipe must also be insulated).
After fitting pipes the pre-charged Condenser is purged following the appropriate instructions depending on the State/Country laws that are applicable. In some State/Countries a vacuum pump will be required to adhere to the applicable laws.
Leak testing of all connections is also carried out by the recommended methods.