SmartConnect Range of Sensors for RV - Technical and Customer Service Guide

Overview

The SmartConnect range offers a suite of sensors designed to enhance the RV experience, including SmartPressure for monitoring tire pressure, SmartTemp for measuring temperatures inside and out, and SmartSense for gauging the level of LPG. This guide provides detailed instructions and specifications for customer service and technical staff to assist users in installing, operating, and troubleshooting these devices.

Package Contents

• 1x SmartSense (LPG level sensor)
• 2x SmartPressure (Tire pressure sensors)
• 1x SmartTemp (Temperature sensor)
• 1x Toolkit

System Requirements

• BMPRO ControlNode103 or BMPRO OdysseyLink103 or later
• Devices must support Bluetooth 4.0+ Low Energy (BLE) for compatibility.

SmartSense Gas Sensor Installation

1. Integration with JHub/Odyssey: Navigate to the SmartSense screen via SmartConnect. Press "Add" to add a sensor, then "Pair". Press the orange SYNC button on the sensor during the app's scanning process.
2. Independent Use: Download the BMPRO SmartSense app. Launch the app and press the orange SYNC button to pair.
3. Physical Installation:
   • Clean the base of the gas bottle to remove dirt or debris.
   • Attach the sensor to the base of the gas bottle using its magnets, ensuring the black rubber pad aligns with the center of the bottle.
   • Place the gas bottle upright on a flat, even surface. Accuracy may be reduced if the bottle is tilted.
   • Allow a few minutes for the contents to settle and the reading to stabilize.

SmartPressure Sensor Installation

1. Navigate to the SmartPressure screen in your JHub or Odyssey app.
2. Press "Pair" at the sensor's installation location, then install the SmartPressure sensor on the corresponding tire.
3. After installation, the app will display the tire pressure and temperature. The tire icon will turn white, indicating successful pairing.
4. To secure the sensor, screw the anti-theft nut anticlockwise and tighten with a wrench.

SmartTemp Sensor Installation

1. Navigate to the SmartTemp screen in your JHub or Odyssey app.
2. Press "Add", then turn on the SmartTemp sensor. When the green light flashes, press "Pair" and select the sensor from the drop-down menu.
3. Successful pairing will display the temperature with its allocated name. Up to four sensors can be installed and managed through the app.

Specifications

SmartTemp Sensor

• Voltage: 3VDC
• Battery Type: CR 2477
• Battery Lifespan: 2 years
• Weight: 19g
• Dimensions: 39 x 39 x 14 mm
• Temperature Range: -20 °C to +60 °C

Troubleshooting

• Sensor Not Pairing: Ensure the device's Bluetooth is on and it supports BLE 4.0+. Restart the device and attempt pairing again.
• Inaccurate Readings: For SmartSense, ensure the gas bottle is on a level surface. For SmartPressure, verify the sensor is properly installed and the tire is at the correct pressure.
• Sensor Not Responding: Check the battery and replace if necessary. Ensure the sensor is within the Bluetooth range of the controlling device.

For further assistance, refer to the detailed guides and FAQs on the BMPRO website or contact technical support directly through the app.