Nothing in cart
Review of Caravans Plus Service
Caravans Plus is my Go To for all my parts. Quick delivery and wide range.
Below is a summary of the contents of this PDF. You can also view or save the original full PDF. The products that this PDF relate to are listed at the bottom.
Install the battery in a dry, cool place, avoiding high heat environments and wet areas such as engine bays, caravan chassis mounts, and gas compartments.
It is recommended to install the battery in the upright position. Ensure a 25mm clearance around the battery for ventilation.
Use supplied battery trays and straps with sufficiently rated fasteners. Avoid mounting near metallic service lines to prevent accidental shorting.
Limit connections to four terminals per battery terminal. Use a fuse block and negative busbar for more than four connections.
Ensure cables are adequately sized for the system's demands. Use insulating terminal boots to prevent accidental shorting.
Connect cables from the heaviest current draw to the lightest on the battery terminals.
Use a charger with a lithium LiFePO4 setting. Set charge voltage between 14.2 - 14.6 Volts and Float between 13.5 - 13.6 Volts.
Recommended charging current is 30% of the battery capacity for longevity.
Avoid chargers with a "Pulse Stage" or "Equalisation Mode" and do not charge directly from an alternator or connect to a start battery with a VSR.
Refer to the battery specifications for maximum discharge current. Ensure cable gauge is appropriate for the discharge.
Do not exceed the BMS rating of the battery. Specific inverter recommendations are provided based on battery model.
Use a battery monitor with a shunt for accurate SOC% readings. Lithium batteries should not be discharged below 20% SOC.
The battery has a built-in low voltage disconnect circuit for protection.
If the battery shuts down, turn off all loads, connect a charging source, and follow the reset procedure as outlined in the manual.
Monitor battery capacity, voltage, temperature, current, cycles, SOC, SOH, alarms, and notifications.
Available for Android and Apple devices.
Do not use for cranking applications, series connect, expose to fire or water, or disassemble. Avoid low voltage states and use matched chargers.
The battery will disconnect at 2.8V per cell (11.2V for 12V battery) to protect itself.
Yes, with considerations for maximum current delivery and annual maintenance.
No, Enerdrive offers higher voltage solutions.
Yes, following the guidelines provided.
No, must be installed in a dry environment.
Must be installed upright.
Detailed specifications for each model are provided, including nominal voltage, capacity, cycle life, charge and discharge specifications, protection features, and mechanical characteristics.
Dimensions and weight for each battery model are provided, with and without trays and straps.
5 years from the date of purchase.
Defects in materials and workmanship under normal conditions.
Contact Enerdrive Support Team for assistance and warranty claims.
This guide is designed to provide comprehensive technical and customer support information for Enerdrive B-TEC Lithium Batteries. For further assistance, contact the Enerdrive Support Team.
Caravans Plus is my Go To for all my parts. Quick delivery and wide range.
ordered some spatre parts off carans plus what great service super fast
The quickest service I have ever had, the parts were perfect, the staff were great,and friendly . I honestly couldn’t say a bad word about my experience