LCD/Plasma Wall Bracket Instruction Manual - Type ARM102

For Customer Service and Technical Staff Reference

Technical Specifications

• Maximum Load: 40kg

• Pitching Angle: +10 degrees to -15 degrees

• Rotation: +5 degrees

• Distance from Wall: 70mm to 230mm

Part List and Installation Components

Ensure all parts are present and in good condition before beginning installation. Do not use defective parts or replace parts with different specifications.

• (A) Self-tap Screw (4)
• (B) Plastic Anchors (4)
• (C) #4 Flat Washer (4)
• (D) QS Flat Washer (4)
• (E) #6 Flat Washer (4)
• (F) M4*8 Screw (4)
• (G) M4*12 Screw (4)
• (H) M5*8 Screw (4)
• (I) M5*12 Screw (4)
• (J) M6*8 Screw (4)
• (K) M6*12 Screw (4)
• (L) Inner Hexagon Spanner S=5 (1)
• (M) Spanner S=13 (1)
• Plastic Cover (2)

Installation Steps

Step 1: Wall Plate Positioning and Drilling

1. Use the wall plate as a template to mark and drill four holes of 10mm diameter and 50mm depth in the vertical wall.
2. Insert four plastic concrete anchors into the drilled holes.

Step 2: Wall Plate Installation

1. Secure the wall plate to the wall using four lag bolts through the holes in the wall plate.

Step 3: Preparing the TV Fixed Plate

1. Insert two fixed plate covers by each other as shown in the figure.
2. Select the appropriate bolts (F-K) based on the TV size and the thread holes at the back of the TV.
3. Screw 4 selected bolts into the thread holes at the back of the TV through the corresponding holes on the TV fixed plate. Ensure the TV fixed plate is mounted symmetrically and evenly on the TV back.

Step 4: Mounting the TV

1. Lift the flat panel TV, aiming the TV fixed plate at the position of the fixed wall plate.
2. Hang the TV by inserting the flange of the TV fixed plate into the inboard of the wall plate. Ensure it is hung firmly before releasing.

Step 5: Securing the TV to the Wall Plate

1. Use the screw bolt to connect the TV fixed plate to the thread holes in the wall plate.
2. Screw down to secure the wall fixed plate and the TV fixed plate together.

Step 6: Adjusting the Viewing Angle

1. Loosen the knob to adjust the angle of the LCD/Plasma TV between +10 degrees and -15 degrees to find a suitable viewing position.
2. Once the desired angle is achieved, tighten the knob to secure the position.

Troubleshooting and Adjustments

• If the TV is not level: Adjust the rotation to +5 degrees as needed to level the TV.
• If the TV seems unstable: Ensure all screws and bolts are tightened securely. Check the wall integrity and the condition of the plastic anchors.
• Adjusting Distance from Wall: The bracket allows for a distance range of 70mm to 230mm from the wall. Ensure this is adjusted as per the desired proximity for optimal viewing and cable management.

Important Notes

• Always verify the weight of the TV does not exceed the maximum load capacity of 40kg.
• Read through all instructions carefully before beginning the installation process.
• Ensure the wall chosen for installation can support the combined weight of the bracket and the TV.
• Regularly check all connections and mounts for any signs of wear or loosening.