Bathroom Module 1100mm x 800mm
The CAMEC bathroom module requires a floor
area of 1100mm x 800mm of which part can be over a wheel arch, if required.
The module includes the one piece shower tray or base, which fits around
the Thetford C200 rear entry cassette toilet.
Behind the toilet fits the Thetford panel which
also includes a covered toilet roll holder. This panel comes up to a
total height above the floor of 825mm - the same height as the vanity
unit with basin, and the small side unit.
There is a top cupboard, and ceiling panel
with included lights that can be located where you like, but best results
are obtained if located where shown.
Note: The mirrors, taps, shower rose
and accessories shown are NOT included.
Below: The ceiling panel is
790mm x 480mm and 45mm deep. It includes 3 x 12volt halogen spot lights.
This is gloss white and the photos show both sides. It does not have
any specific mounting points.
|
Wall Cupboard: The
left image show the rear, and the location of the screw mounting
points. These are not drilled, so you can mount by gluing or at other locations.
The right image, shows
the front, with the upper door closed. This door has a simple hinge system,
and will not stay up unaided. It has a magnetic catch to hold closed. See
bottom image with the door open.
Shower Base Below: The
shower base takes the entire space of 1100 x 800, but as shown in the first
image, the area under where the vanity sits is raised and is designed to accommodate
part of the wheel arch or other protrusion if required. From the right rear
corner, you have clearance 450mm left, 250mm forward and 250mm high.
The cutout for the Thetford C200 toilet
base, sits just below the lower lip on the toilet, for a neat and easy to
waterproof join.
The centre of the 25mm waste location
is slightly recessed and is 180mm from the right hand side (as shown in the
first image), and 130mm in from the front face. The waste is not included.
Below: See the large recess for the wheel arch.
Vanity Below: The vanity
comes as two sections. The corner basin with a 25mm waste hole (waste not
included) and the corner cabinet shell. There are no included shelves, but
the door (light grey) opens down and is held closed with a magnetic catch.
The vertical mounting wings are covered by the Thetford panel, and the small
side panel.
Thetford panel below: The
panel fits behind the C200 toilet and allows access to remove the cassette
from the rear. It will suit the electric or manual model. The toilet roll
holder keeps the toilet paper dry when using the shower. Left
image show the front face, right image shows it from the
rear. This panel fits in behind the shower base at the bottom, and beside
the vanity unit.
Small Cupboard: Below,
the left image shows the two components together. The
right image is a rear view of the components.
.